Loading ...
Loading ...
Loading ...
10 11
EN
onto the internal support and pin at the bottom, then push
the PUSH symbol fully in until it clicks into place.
N.B.: If the brewing unit is dicult to insert, you must
rst adapt it to the right dimensions by pressing it forcefully
from the bottom and top as shown in the gure.
7. Once inserted, make sure the two red buttons have snapped
out.
8. Replace the drip tray and waste coee container.
9. Close the service door.
Cleaning the milk container
Important! Always clean the tubes inside the milk
container (C) when you prepare milk.
If there is still milk in the container, do not leave it out of the
refrigerator for longer than strictly necessary.
Clean the container each time you prepare milk as described in
Note 3 in the section “Making cappuccino”.
All components can be washed in a dishwasher, placing them in
the top basket of the dishwasher.
1. Turn the lid of the milk container clockwise then remove it.
2. Remove the milk spout and intake tube.
Groove
Frothed milk regulator
3. Remove the frothed milk regulator by pulling it outwards.
4. Wash all the components thoroughly with hot water and
mild washing-up liquid.
Make sure there are no milk residues left inside the holes
and the groove on the ne end of the frothed milk regula-
tor.
5. Check that the intake tube and spout are not clogged with
milk residues.
6. Replace the frothed milk regulator, milk spout and intake
tube.
7. Replace the milk container lid.
CHANGING AND SETTING MENU
PARAMETERS
When the appliance is ready, you can use the internal menu to
modify the following parameters and functions:
• Chooselanguage
• Rinsing
• Shut-otime
• Setclock
• Starttime
• Auto-start
• Temperature
Support
Pin
spout
milk intake tube
Hole
Hole
Loading ...
Loading ...
Loading ...