Loading ...
Loading ...
Loading ...
09 Wheels and tyres
09
324
* Option/accessory, for more information, see Introduction.
Changing wheels - fitting
It is important that the procedure for fitting
the wheel is carried out correctly.
Installation
WARNING
Never crawl under the car when it is raised
on the jack.
Passengers must leave the car when it is
raised on the jack. If a wheel must be
changed in a trafficked environment, pas-
sengers must stand in a safe place.
1. Clean the contact surfaces between
wheel and hub.
2. Put on the wheel. Tighten the wheel bolts
thoroughly.
3. Lower the car so that the wheels cannot
rotate.
4. Tighten the wheel bolts crosswise. It is
important that the wheel bolts are tight-
ened properly. Tighten to 140 Nm. Check
the torque with a torque wrench.
5. Refit the plastic caps on the wheel bolts.
NOTE
•
After a tyre has been inflated, always
refit the dust cap in order to avoid
damage to the valve from gravel, dirt,
etc.
•
Only use plastic dust caps. Metal dust
caps can rust and become difficult to
unscrew.
When changing to another tyre
dimension
Applies to cars with tyre pressure monitor-
ing
3
: Contact an authorised Volvo workshop
for updating the software at each change of
tyre dimension. A software download may be
necessary both when changing to larger and
smaller dimensions, and also when switching
between summer and winter wheels.
Related information
•
Changing wheels - removing wheels
(p. 321)
•
Jack* (p. 326)
•
Warning triangle (p. 325)
•
Wheel bolts (p. 320)
3
Standard in certain markets.
Loading ...
Loading ...
Loading ...