Loading ...
Loading ...
Loading ...
❒ take the wrench A fig. 111 and
loosen the fixing bolts by about one
turn;
❒ position the jack under the vehicle,
near the wheel to be changed;
❒ operate the device A fig. 112 to
extend the jack until the top of the jack
B fig. 113 fits correctly into the side
member C (next to the mark
on the
side member);
❒ alert any bystander that the vehicle is
about to be raised; all persons should
be kept away from the vehicle and
nobody must touch it until it has been
lowered;
❒ fit handle D fig. 112 into the housing
in device A, operate the jack and raise
the vehicle until the wheel is a few
centimetres from the ground;
❒ remove the wheel cap after loosening
the 3 fixing bolts and finally loosen the
fourth bolt and extract the wheel (only
for versions with wheel caps fixed
by bolts);
❒ make sure the contact surfaces
between space-saver wheel and hub
are clean so that the fastening bolts will
not come loose;
❒ fit the space-saver wheel by inserting
the first bolt for two threads into the
hole closest to the valve;
❒ take the wrench A fig. 111 and fully
tighten the fixing bolts;
❒ operate the jack handle D fig. 112 to
lower the vehicle. Then extract the jack;
❒ use the wrench A fig. 111, to fully
tighten the bolts, passing alternately
from one bolt to the opposite one;
❒ when replacing an alloy wheel rim it is
advisable to place it upside down,
with the aesthetic part facing upwards.
REFITTING THE
STANDARD WHEEL
51)
Following the procedure described
previously, raise the vehicle and remove
the space-saver wheel.
Versions with steel rims
Proceed as follows:
❒ make sure the contact surfaces
between standard wheel and hub are
clean so that the fastening bolts will not
come loose;
❒ fit the standard wheel by inserting the
first bolt by 2 threads into the hole
closest to the inflation valve;
❒ fit the hub cap, aligning the crescent
hole with the bolt already fitted, then
fit the other bolts;
❒ using the wrench provided, tighten
the fastening bolts;
111
F1D0074
112
F1D0075
113
F1D0076
113
Loading ...
Loading ...
Loading ...