Loading ...
Loading ...
Loading ...
WARNING
136) If the replaced fuse blows again,
contact a Fiat Dealership.
137) Never replace a blown fuse with metal
wires or other material.
138) Never replace a fuse with another with
a higher amp rating; DANGER OF FIRE.
139) If a general fuse (MEGA-FUSE,
MIDI-FUSE, MAXI-FUSE) cuts in, do not
attempt any repair and contact a Fiat
Dealership.
140) Before replacing a fuse, make sure
that the ignition key has been removed and
that all the other devices are switched off
and/or deactivated.
141) If a general protection fuse for safety
systems (airbag system, braking system),
power unit systems (engine system,
transmission system) or steering system
blows, contact a Fiat Dealership.
WARNING
50) If you need to wash the engine
compartment, take care not to directly hit
the fuse box and the window wiper motors
with the water jet.
CHANGING A WHEEL
142) 143) 144) 145) 146)
JACK
Important notes:
❒ the jack weight is 1.76 kg;
❒ the jack requires no adjustment;
❒ the jack cannot be repaired and in
the event of a fault it must be replaced
by another original one;
❒ no tool other than its cranking device
may be fitted on the jack.
CHANGING PROCEDURE
Proceed as follows:
❒ stop the vehicle in a position that is
not dangerous for oncoming traffic
where you can change the wheel safely.
The ground should be flat if possible,
and sufficiently firm;
❒ switch off the engine, pull up the
handbrake and engage the 1
st
gear or
reverse. Wear the reflective safety
jacket (compulsory by law) before
getting out of the vehicle;
❒ open the luggage compartment, pull
tab A fig. 109 and lift up the mat;
❒ using the wrench A fig. 110 located
in the tool box, loosen the locking
device, take the tool box B and place it
close to the wheel to be replaced.
Then take the space-saver wheel C.
For the Panda VAN and Panda 4x4
versions, the jack and the tools can be
located under the passenger side
front seat;
109
F1D0072
110
F1D0073
112
IN AN EMERGENCY
Loading ...
Loading ...
Loading ...