Loading ...
Loading ...
Loading ...
16
Router Table Assembly
FINAL INSTALLATION OF THE ROUTER
MOUNTING PLATE (Fig. 11)
1.Place the router mounting plate, with router attached,
on the leveling screws in the tabletop.
NOTE: Be careful not to trap the cord between the
router mounting plate and the router tabletop.
2.Recheck the router mounting plate to be sure it is
level. If necessary, loosen the locking nuts and adjust
the leveling screws with the allen wrench as needed.
Once the router mounting plate is level, retighten the
locking screws.
3.Secure the router mounting plate (3) to the table with
four #10-32 x 1″ pan-head Phillips machine screws
(28) and #10-32 ESNA stop nuts (25) (Fig. 11)
through the inner corner holes in the plate. Tighten
the screws snugly, but do not overtighten.
TO REMOVE THE ROUTER AND/OR
ROUTER MOUNTING PLATE
To remove the router from the mounting plate, you
must first remove the router mounting plate from the
router table.
THE FENCE MUST BE REMOVED FROM THE
ROUTER TABLE WHEN REMOVING OR
REINSTALLING THE ROUTER MOUNTING PLATE.
Make sure that the router is NOT
plugged into a power outlet when installing into the
table, removing from table, making adjustments or
changing accessories. Router could accidentally start.
1.Loosen the four #10-32 x 1″ pan-head Phillips
machine screws (28) holding the router mounting
plate to the tabletop.
2.Lift the router mounting plate and router upwards
from the tabletop.
3.Remove the countersunk machine screws securing
the router to the mounting plate.
4.When reinstalling the router mounting plate, be sure
that the plate is level with the tabletop. If needed,
readjust as described above.
3
28
FIG. 11
OVER-TABLE HEIGHT ADJUSTMENT
The router adapter plate features an access hole to
allow use with the over-table height adjustment feature
on the Bosch 1617 series routers. Refer to your router
manual for additional information on using this feature.
For the Porter Cable 892 and 895 and the Milwaukee
5615 and 5616 model routers, it is necessary to drill an
access hole to accommodate the over-table height
adjustment:
1.Remove the subbase from the router and align
the mounting holes in the subbase with the
corresponding mounting holes in the adapter plate.
Be sure to orient the subbase so that the router
switch will be toward the front of the table.
2.Using a pencil or centerpunch, mark the location of
the over-table height adjustment hole on the router
adapter plate.
3.Remove the subbase from the adapter plate and
carefully drill the over-table height adjustment hole.
4.Make sure that the hole will accommodate the height
adjustment tool for your router. Remove any burrs or
rough edges with sandpaper.
25
Loading ...
Loading ...
Loading ...