Loading ...
Loading ...
Loading ...
9
GEAppliances.com
Preparing for Vacation
For long vacations or absences, remove
food and unplug the refrigerator. Move
the refrigerator control to the
0 (off)
position
and clean the interior with a baking soda
solution of one tablespoon (15 ml) of
baking soda to one quart (1 liter) of water.
Leave the doors open.
Set the icemaker power switch to the
O (off)
position or move the feeler arm to the
STOP
(up) position (depending on model) and
shut off the water supply to the refrigerator.
If the temperature can drop below freezing,
have a qualified servicer drain the water
supply system (on some models) to prevent
serious property damage due to flooding.
Preparing to Move
Secure all loose items such as grille,
shelves and drawers by taping them
securely in place to prevent damage.
Be sure the refrigerator stays in an upright position
during moving.
Some models have only one light.
Freezer Compartment Dome Light (on some models)
CAUTION:Light bulbs may be hot.
Unplug the refrigerator.
The bulb is located behind a light
shield at the back of the freezer
compartment. To remove, squeeze
the top and bottom of the shield and
pull the shield off.
After replacing with an appliance bulb
of the same or lower wattage, replace
the shield.
Plug the refrigerator back in.
Replacing the light bulbs.
Setting either or both controls to 0 (off) does not remove power to the light circuit.
Refrigerator Compartment—Upper Light
CAUTION:Light bulbs may be hot.
Unplug the refrigerator.
The bulbs are located at the top of the
compartment near the opening.
Replace with an appliance bulb of
the same or lower wattage.
Plug the refrigerator back in.
Light shield
Consumer Support
Troubleshooting TipsOperating Instructions
Safety Instructions Installation Instructions
Loading ...
Loading ...
Loading ...