Loading ...
Loading ...
Loading ...
E-27
Memory Function / Monitor / Sensors / Auto Detection
Auto Detection
The air purifi er performs automatic operation by detecting room air contamination using the “Odor Sensor” and “Dust
Sensor”, and room air temperature and humidity using the “Temperature / Humidity Sensor”.
During the fi rst 3 minutes after the power is turned on, the unit will check the air condition of the room.
The purifi er operates even while it checks the air condition of the room.
During this time, the “Air Sensor” fl ashes green.
After checking the air condition, the “Air Sensor” will display the room air contamination using the “Odor Sensor”
and the “Dust Sensor”.
If you plug in the power cord in an environment containing contaminated air, the sensitivity of the sensor may be
reduced.
To clean the air of the room, operate in “High” or “Max”. Or open a window and unplug the power cord from the AC
outlet when ambient air is clean and plug it back in after 10 minutes.
Vibration Sensor
The sensor detects a fall and impact on the unit. (Installed inside the unit)
The operation may stop due to tilting of the unit, strong vibrations or impact of a collision.
When the operation stops, “ ” is displayed on the temperature / humidity monitor and the unit can no longer operate. (P.E-39)
Adjusting Sensory Sensitivity Setting
Sensitivity of the “Odor Sensor” and “Dust Sensor” which performs automatic switching of airfl ow rate can be ad-
justed in 3-step fashion.
You can adjust the sensor sensitivity setting as desired.
The “Odor Sensor” and “Dust Sensor” are similarly adjusted.
While the sensitivity is being displayed (about 10 seconds),
continue long-pressing for about 3 seconds, while pressing once more.
While pressing , long-press for about 3 seconds
The sensitivity display will change from .
The current sensitivity is indicated and displayed. (Factory setting is )
Furthermore, when switching sensitivity, repeat procedure .
When repeating, the sensitivity display will switch like this
…
.
About 10 seconds after the sensitivity display has been switched, it will disappear and the selected sensor sensitivity will be set.
1
2
3
2
2
1
Display
Air
flow
Display
Air
flow
Medium
Display
Low
High
Sensor
Sensitivity
Note
Switching the sensor sensitivity is not supported in the “PM2.5 Sensor” cycle. (P.E-24)
EP-M70E_EN.indd 27EP-M70E_EN.indd 27 2017/2/23 17:27:442017/2/23 17:27:44
Loading ...
Loading ...
Loading ...