Woke up the panel on safe, press "1" twice, and then press "Settings" under the key panel, the blue light will flash.
4
GS-103
9.9lbs / 4.5kg
11.8 * 9.1 * 2.6 in(300 * 230 * 65 mm)
FCC Regulatory Compliance
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
LED Light
Mounting Bracket
Panel (Buttons & Biometric Scanner)
The setting key is under the panel
Holes of Mounting Hook
Plug Nut Hole
Fixed Hole
Emergency Keyhole
Buttstock Foam
Mounting Screws x 6
Thumb Screw x 2
Backup Keys x 2
Battery Compartment
LED Light
Type C
1
2
3
4
5
6
7
8
9
10
11
12
13
14
- R
eorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The distance
between user and device should be no less than 20cm.
