FLUKE 9100S-B-156 User Manual for the Fluke 9100S-B-156 Dry Block Calibrator with block B, 95 to 707°F

Loading ...

Controller Operation

Calibration Parameters

HALF Newduplexmodesetting

Press “SET” to accept the new setting or “EXIT” to abort the operation and skip to the

next parameter in the menu.

6.11.4 Linefeed

The nal parameter in the serial interface menu is the linefeed mode. This parameter

enables (on) or disables (off) transmission of a linefeed character (LF, ASCII 10) after

transmission of any carriage-return. The linefeed parameter is indicated by,

LF Flashesforonesecondandthentheseriallinefeedsetting

isdisplayed

On Currentlinefeedsetting

The mode may be changed using the up or down arrows (u d).

OFF Newlinefeedsetting

Press “SET” to accept the new setting or “EXIT” to abort the operation and skip to the

next parameter in the menu.

6.12 Calibration Parameters

The operator of the instrument controller has access to a number of the calibration

constants namely the Hard Cutout, R0, ALPHA, and DELTA. These values are set at

the factory and must not be altered. The correct values are important to the accuracy

and proper and safe operation of the instrument. Access to these parameters is

available to the user so in the event the controller memory fails the user may restore

these values to the factory settings. The user should have a list of these constants and

their settings with the instrument manual.

CAUTION: DO NOT change the values of the instrument calibration constants

from the factory set values. The correct setting of these parameters is important

to the safety, proper operation, and performance of the instrument.

The calibration parameters menu is indicated by,

CAL Calibrationparametersmenu

Press “SET” ve times to enter the menu. The calibration parameters menu contains

the parameters, Hard Cutout, R0, ALPHA, and DELTA, which characterize the

resistance-temperature relationship of the platinum control sensor. These parameters

may be adjusted to improve the accuracy of the calibrator.

The calibration parameters are accessed by pressing “SET” after the name of the

parameter is displayed. The value of the parameter may be changed using the up or

down arrow. After the desired value is reached, press “SET” to set the parameter to the

1.888.610.7664 sales@GlobalTestSupply.com

Fluke-Direct.com

Loading ...

FLUKE 9100S-B-156 Dry Block Calibrator with block B, 95 to 707°F