Loading ...
Loading ...
Loading ...
1 100. Set-pointmemory1location,100°Ccurrentlyused
To change to another set-point memory press the up or down arrow.
4 300. Newset-pointmemory4location,300°C
Press “SET” to accept the new selection and access the set-point value. Press “EXIT” to
continue and to ignore any changes.
S
Acceptselectedset-pointmemory
6.2.2 Set-point Value
The set-point value may be adjusted after selecting the set-point memory and pressing
“SET”.
4 200. Set-point4valuein°C
If the set-point value does not need to be changed, press and hold “EXIT” to resume
displaying the well temperature. To change the set-point value, press “SET” and then
press the up or down arrow.
220.0 Newset-pointvalue
When the desired set-point value is reached, press “SET” to accept the new value and
access the temperature scale units selection. If “EXIT” is pressed, any changes made to
the set-point are ignored.
S
Acceptnewset-pointvalue
6.2.3 Temperature Scale Units
The temperature scale units of the controller maybe set by the user to degrees Celsius
(°C) or Fahrenheit (°F). The units are used in displaying the well temperature, set-point,
proportional band, and high limit.
Press “SET” after adjusting the set-point value to change display units.
Un= C Scaleunitscurrentlyselected
Press the up or down arrow to change the units.
Un= F Newunitsselected
Press “SET” to accept the new units or “EXIT” to cancel.
Note: The temperature scale units may also be changed by pressing “SET” and u when
the temperature is displayed. This action toggles the units between °F and °C.
6.3 Scan
The scan rate can be set and enabled so that when the set-point is changed the dry-well
heats or cools at a specied rate (degrees per minute) until it reaches the new set-point.
With the scan disabled the dry-well heats or cools at the maximum possible rate.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...