Loading ...
Loading ...
Loading ...
Insulation Tester
Safety Information
3
•
Remove all probes, test leads, and accessories that are
not necessary for the measurement.
•
Keep fingers behind the finger guards on the probes.
•
Use the correct terminals, function, and range for
measurements.
•
Place test leads in proper input terminals.
•
Do not work alone.
•
Do not use in distribution systems with voltages higher
than 1100 V.
•
Use only recommended test leads.
•
Remove all power from the circuit under test and
discharge circuit capacitance before testing resistance
or capacitor with the tester.
•
Results of measurement can be adversely affected by
the impedances of additional operating circuits
connected in parallel or by transient currents.
•
Before and after testing, confirm that the Product does
not indicate the presence of a hazardous voltage. If a
hazardous voltage is shown on the display, remove
power from the circuit under test or allow the
installation capacitance to fully discharge.
•
Do not disconnect the test leads before a test has been
completed and the test voltage at the terminals has
returned to zero. This ensures that any charged
capacitance is fully discharged.
•
Use the guard terminal only as specified in this manual.
Do not allow other foreign objects to contact the guard
terminals as safety can be compromised.
•
Remove the input signals before you clean the
Product.
•
Use only specified replacement parts.
•
Repair the Product before use if the battery leaks.
•
Do not operate the Product with covers removed or the
case open. Hazardous voltage exposure is possible.
•
Have an approved technician repair the Product.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct
.com
Loading ...
Loading ...
Loading ...