FLUKE 1550C Insulation Resistance Tester, 5 kV, 1 TΩ

User Manual for the Fluke 1550C Insulation Resistance Tester, 5 kV, 1 TΩ - Page 6

For 1550C.

PDF File Manual, 25 pages, Read Online | Download pdf file

1550C photo
Loading ...
Loading ...
Loading ...
1550C/1555
Users Manual
2
Safety Information
A Warning identifies hazardous conditions and procedures that are
dangerous to the user. A Caution identifies conditions and procedures
that can cause damage to the Product or the equipment under test.
XW Warning
To prevent possible electrical shock, fire, or personal
injury:
Carefully read all instructions.
Read all safety information before you use the Product.
Do not alter the Product and use only as specified, or
the protection supplied by the Product can be
compromised.
Do not use the Product around explosive gas, vapor, or
in damp or wet environments.
Do not use the Product if it is altered or damaged.
Do not use the Product if it operates incorrectly.
Use Product-approved measurement category (CAT),
voltage, and amperage rated accessories (probes, test
leads, and adapters) for all measurements.
Do not exceed the Measurement Category (CAT) rating
of the lowest rated individual component of a Product,
probe, or accessory.
Do not use in CAT III or CAT IV environments without
the protective cap installed on test probe. The
protective cap decreases the exposed probe metal to
<4 mm. This decreases the possibility of arc flash from
short circuits.
Comply with local and national safety codes. Use
personal protective equipment (approved rubber
gloves, face protection, and flame-resistant clothes) to
prevent shock and arc blast injury where hazardous
live conductors are exposed.
Examine the case before you use the Product. Look for
cracks or missing plastic. Carefully look at the
insulation around the terminals.
Do not use test leads if they are damaged. Examine the
test leads for damaged insulation and measure a
known voltage.
Do not touch voltages >30 V ac rms, 42 V ac peak, or
60 V dc.
Do not apply more than the rated voltage between the
terminals or between each terminal and earth ground.
Measure a known voltage first to make sure that the
Product operates correctly.
Limit operation to the specified measurement category,
voltage, or amperage ratings.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct
.com
Loading ...
Loading ...
Loading ...