Loading ...
Loading ...
Loading ...
Swing Barrier • User Manual
18
2.5 RS485 Baud
Set the baud rate of the RS485
2.6 Reset
Reset all setting to factory default.
2.7 Restart
Restart controller
3. Factory Test
3.1 Cycle Test
Open and close door cycle test
3.2 Input Check
Check input interface status
3.3 Output Test
Output interface test
4 Trouble shooting and maintenance
4.1 Trouble shooting
The box of control is buckle type ,It can open the upper cover of the buckle from the side.
Fault 1: Gate automatically open when people in to first sensor?
Answer：Change pass mode two way free to two way card in the menu.
Fault 2: swipe into the first sensor, Gate give alarm and close immediately?
Answer：This means that the signal connection is opposite, exchange the open signal connect
terminal of SW1 Gnd to SW2 Gnd.
Fault 3: indicator light is not bright?
Answer：Take the other indicator or control board from other lane and check it
Fault 4: is there an indicator that shows the wrong direction?
1 2 3 4 5 6 7 8 9
ESC ENT
Control board
Loading ...
Loading ...
Loading ...