Loading ...
Loading ...
Loading ...
Sarix® Multi Enhanced Installation Manual
C6730M | 03/30/23
30
Surface Mount Installation
Camera Package Contents
The Sarix Multi Enhanced camera has a variety of different mounting, dome cover, camera and
accessory options. The components for each Sarix Multi Enhanced camera will arrive in a camera
package, a dome cover package, and a mounting adapter package.
Ensure the camera package contains the following:
l
Pelco Sarix Multi Enhanced Camera module. A 3- or 4-sensor camera module with 3 MP, 5 MP, or
4K (8 MP) resolution per sensor.
l
Audio, external power, and I/O pigtail cable connector
l
RJ45 CAT5E plugs (x2)
l
RJ45 connector waterproof gland
Ensure the Surface mount adapter package contains the following:
l
Surface mount adapter (IMD1-SMT)
l
Installation instructions sheet
l
Mounting template sticker
Ensure the dome cover package contains the following:
l
Clear or smoked dome bubble and cover (IMD1-SPLD1 or IMD1-SPLD0)
If you are installing the camera with the optional IR illuminator, ensure the package includes the
following:
l
IR illuminator ring (IMD1-IR)
Surface Mount Installation Steps
Complete the following sections to install the device.
Installing the Surface Mount Adapter
Follow this procedure to route camera cables and install the surface mount adapter (IMD1-SMT) to the
mounting surface.
1. Determine where the cables will enter the camera. The surface mount adapter has two cable entry
holes: one on the side and one on the bottom of the mounting adapter.
l
Use the supplied closure plug to fill the unused cable entry hole.
l
When installing outdoors, wrap the threads of the closure plug with plumber's tape to create a
watertight seal.
Note:
Only use vandal-resistant conduits to route cables into the mounting adapter. Vandal-
resistant conduits will protect the cables and compliment the camera's vandal-resistant
design.
Note:
When installing the
Sarix Multi Enhanced
surface mount camera outdoors, ensure
the conduit and its fitting are designed for outdoor use and have a suitable IP rating. Always
apply silicone sealant to seal the cable entry hole and prevent excessive moisture from
entering the camera.
2. If you are using the rear cable entry hole:
Loading ...
Loading ...
Loading ...