Loading ...
Loading ...
Loading ...
1. Raise the Opener
Raise the opener onto a stepladder. Use extra spacers on top of the ladder if the ladder is not tall
enough.
Sectional Door
Carefully raise the door to the fully
open position. Be sure the door is
clear from the rail or any other part
of the opener.
Place a 2x4 laid flat on the top
section beneath the T-rail.
2. Attach the Hanging Brackets
Hanging brackets should be angled to provide rigid support. Measure the distance from the motor
unit to the structural support. Cut and bend the hanging brackets as required.
One-piece Jamb Door
Carefully raise the door to the fully
open position so that it is parallel to
the floor.
Position the opener so that top of
the opener head is level with the top
of the opened door.
For an “open-seam” garage, attach the hanging brackets directly to the
joists with 2 lag screws.
On a finished ceiling, attach a sturdy metal bracket
(not included) to structural supports before installing
3. Attach the Opener to the Hanging Brackets
Attach the opener to the hanging brackets with two bolts and nu ts.
Ensure the T-rail is centred over the door. Remove the 2x4.
WARNING
• To avoid possible serious injury from a falling garage door opener, fasten it securely
to structural supports of the garage. Concrete anchors must be used if installing any
brackets into masonry.
Bracket (not included)
Bolts and Nuts (not included)
HANG THE OPENERHANG THE OPENER HANG THE OPENER
17
17 1818
G1 (x2)
G2 (x2)
D3 (x2)
D3 (x2)
Loading ...
Loading ...
Loading ...