Loading ...
Loading ...
Loading ...
CONNECT THE OPENER TO POWER
CONNECT THE OPENER TO POWER
CONNECT THE OPENER TO POWER
1. Connect AC Power
Plug motor unit into grounded outlet. If a grounded outlet is not
available, contact a qualified electrician to install a proper outlet.
DO NOT ACTIVATE THE OPENER UNTIL INSTRUCTED.
WARNING
• If permanent wiring is required by your local code, have a licensed electrical contractor follow
the procedures outlined in this manual. Disconnect power to the circuit before removing cover.
• Be sure power is not connected to the opener and disconnect power to circuit before removing
cover to establish permanent wiring connection.
• Garage door installation and wiring must be in compliance with all local electrical and building
codes.
• Never use an extension cord, 2-wire adaptor, or change plug in any way to make it fit outlet. Be
sure the opener is grounded.
• The opener has a grounded type plug for your protection and only fit into a grounding type outlet.
Do not change the plug in any way.
3. Permanent Wiring/Remove the Power Cord
2. Permanent Wiring/Remove Cover
Be sure the power cord is unplugged. Remove the screws from the
cover of the opener.
4. Permanent Wiring/Remove the Bushing
Be sure the power cord is unplugged. Cut the cord about
6” (15 cm) above the bushing.
5. Permanent Wiring/Hardwire the Opener
Connect the conduit to the opener with the proper termination. Connect conduit wiring to opener wiring
with wire nuts (not included). Install the bottom cover and screws.
Green – Ground
White – Neutral
Black – Hot
Remove the bushing with pliers.
2525 2626
Loading ...
Loading ...
Loading ...