Loading ...
Loading ...
Loading ...
NOTE
Remove the spring bracket from the mounting bracket if installing to the wall or floor.
1. Slide the sensor from the mounting bracket.
2. Slide the spring bracket from the mounting bracket.
3. Re-install and secure the sensor to the mounting
bracket.
6. Align the Wireless Safety Beam Sensor
7. Testing with Obstruction
NOTE
If the sensor LED does not glow steadily, check the following:
I. Power to the sensor is installed properly.
II.
III.
Check alignment.
Check for dirt on lens, or sun shining into lens.
• Be sure to stay out of the beam’s path while aligning.
Align the sensors
Slave sensor unit
2929 3030
1
2
3
1. Press the ‘SET’ button once on the Wireless Safety Beam Sensor
(Master unit).
2. The blue LED flashes quickly.
3. Slide the mounting bracket up or down or can also be adjusted by
a slight bend if needed for alignment.
4. Once the Wireless Safety Beam Sensor is aligned properly, the
blue LED will stay on. The sensors will return to normal operation
after stable for 10 seconds.
Master
sensor unit
NOTE
- Alignment is required
- Replace battery
Light Status
Master unit Slave unit
Action
OFF
ON
OFF
ON -The door is closing
With the sensors properly aligned, place an
obstacle in the path of the beam. Press the
[SET] button once on the Master sensor, the
Master sensor’s blue LED should be on, the
Slave sensor’s red LED should be off.
Setup The Radio Module
2. Insert the Radio Module to the socket in the garage
door opener.
3. Power up the garage door opener.
1. Unplug the power cord of your garage door opener
before installation.
4. Press the [SET] button on the Radio Module once,
its green LED will flash indicating the Radio Module
is ready to use.
Programming The Wireless Safety Beam Sensor
1. Press and release the [SET] button on the Radio Module.
2. The green LED will flash for 15 seconds.
3. Press and hold the [SET] button on the Wireless Safety Beam
Sensor (Master unit) for 5 seconds.
4. The blue LED in the Wireless Safety Beam Sensor will flash
slowly. Release the [SET] button.
INSTALL SAFETY BEAM SENSOR
INSTALL SAFETY BEAM SENSOR
Loading ...
Loading ...
Loading ...