Loading ...
Loading ...
Loading ...
1.
Connect the opener to an approved
power source. The dot in the LED
display stays on.
2.
Press and hold button on the
wall console for 5 seconds until the
LCD display shows the number “1” and
up and down arrows are flashing.
3.
Press the [] button until the door is
in fully open position.
4.
Press the [
] button to confirm the
door position.
5. The LCD display will show the number
“2”.
6. Press the [] button until the door
is in fully closed position.
7. Press the [
] button again to
confirm.
8. The LED light will flash 3 times when
the travel limit settings are completed.
9. The LCD display will flash the number
“3”.
10. Press the [
] button to open the
garage door. The flashing “3” will
change to solid.
11. The LED light will flash 3 times again
when the door is fully opened.
Program your garage door opener with following Option 1 or Option 2.
Option 1: from the Wall Console
While programming, the and buttons can be used to move the door as needed.
PROGRAMMING GUIDE – LCD WALL CONSOLE (ATOMS+ ONLY)
TM
INSTALL SAFETY BEAM SENSOR
Loading ...
Loading ...
Loading ...