Loading ...
Loading ...
Loading ...
A. Set Up Travel Limit and Open/Close Force
1. Connect the opener to an approved
power source. The dot in the LED
display stays on.
2. Press and hold [Set] button for
5 seconds until the LED display shows
the number “1”. Release the [Set]
button.
3. Press the [] button until the door is in
fully open position.
4. Press the [Set] button to confirm
the door position.
SET DOOR TRAVEL
LIMIT (OPEN/CLOSE)
5. The LED display will show the number
“2”.
6. Press the [] button until the door
is in fully closed position.
7. Press the [Set] button again to
confirm.
8. The LED light will flash 3 times when
the travel limit settings are completed.
SET DOOR TRAVEL
LIMIT (CLOSE/OPEN)
9. The LED display will show the number
“3”.
10. Press the wall button to open the
garage door to its fully open position.
11. The LED light will flash 3 times.
LEARN DOOR FORCE
(OPEN/CLOSE)
PROGRAMMING GUIDE
While programming, the and buttons can be used to move the door as needed.
Option 2: from the Garage Door Opener
12. The LED display will show the number
“4”.
13. Press the wall button again to close the
garage door to its fully closed position.
14. The LED display will turn off.
LEARN DOOR FORCE
(CLOSE/OPEN)
B.
Press the [Set] button to confirm.
Programming Remote Controls
15.
1. Press the [Set] button for one
second. The LED display will show
the letter “P”.
LEARN WIRELESS
CONTROL
2. Program a Remote:
Within 2 minutes, press any
button on the remote that you
would like to program to the
opener.
Once the button on the remote is
programmed, the LED display will
turn off and emit one beep
indicating the programming has
been successful.
3.
PROGRAMMING GUIDE
WARNING
•
During the Force Adjustment, do not obstruct the door’s travel or the safety safety beam sensor.
- ATOMS & ATOMS+
TM
TM
- ATOMS & ATOMS+
TM
TM
Loading ...
Loading ...
Loading ...