Loading ...
Loading ...
Loading ...
3029
STEP 9: INSTALL OIL TUNNEL OR Grease cup (NOT AVAILABLE FOR ALL
MODELS)
Drop oil tunnel into recess support near rear of hood. Refer to the image above.
STEP 10 INSTALL BAFFLE FILTERS
Install baffle filters. Refer to the image above for the following the first three steps:
NOTE: The middle filter has to be installed last where it should be taken out first when
you want to remove other filters.
1. Angle baffle filter toward back of hood.
2. Lift the baffle filter up above horizontal level.
3. Slide forward into slot towards the front of the hood.
4. Slide the installed baffle filter to either left or right until it stops.
5. Repeat step 1 to 4 to install the next set. Make sure you slide to opposite
direction from the previous installed filter.
To remove the baffle, please the process.
INSTALLATION
ALPINE UNDER CABINET MODELS
Alpine Under Cabinet Installation
Alpine Under Cabinet Keys
OPERATION
ALPINE UNDER CABINET MODELS
Alpine Under Cabinet Keys
• Power: Turn ON/OFF the range hood and activate power-off delay timer
(3mins).
• Low Speed: Light frying/boiling.
• Medium Speed: Frying/wok cooking/heavy boiling.
• High Speed: Intensive frying and wok cooking.
• Light: Turn ON/OFF
Adjusting the blower (motor) speed: Press the power key then press any speed
buttons one time , the blower will start at any speed, press same button again , shut
down the blower.
Adjusting the timer function: Turn the hood on at any speed and press the power-off
delay button one time, it will enter timer mode, power-off delay digital timer will
begin countdown. Press again ,the blower will shut down.
Never put your hand into area housing the fan while the fan is operating!
The remote control is a 433M high frequency remote control.
The distance of the remote control is 10 meters. The signal can
pass through the wall.
It needs to match code with the hood to use it for the first time.
Press Lamp key on range hood for 5 seconds. Once the light
of the lamp button on the hood flickers, press any button on
the remote control. If the LED of lamp button stops flickering,
the matching is done.
Alpine Under Cabinet Installation
Alpine Under Cabinet Operation
Loading ...
Loading ...
Loading ...