Loading ...
Loading ...
Loading ...
1817
• If hood looks splotchy, use a stainless steel cleaner to clean the surface of
the hood. Avoid getting cleaning solution on or into the control panel. Follow
directions of the stainless steel cleaner. CAUTION: Do NOT leave on too long
as this may cause damage to hood finish. Use soft towel to wipe off the cleaning
solution, gently rub off any stubborn spots. Use dry soft towel to dry the hood.
• After cleaning, you may use non-abrasive stainless steel polish such as 3M ® or
ZEP®, to polish and buff out the stainless luster and grain. Always scrub lightly,
with clean cotton cloth, and with the grain.
• Do NOT allow deposits to accumulate or remain on the hood.
• Do NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere
to the surface and cause rusting.
• Do NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds
to remain in contact with stainless steel for extended periods. Many of these
compounds contain chemicals which may be harmful. Rinse with water after
exposure and wipe dry with a clean cloth.
• Cleaning grease filter/stainless steel filter: IMPORTANT: Drain oil from oil
containers before oil and residue overflow!
• The metal filters fitted by the factory are intended to filter out residue and grease
from cooking. They do not need to be replaced on a regular basis but are
required to be kept clean.
• Filters should be cleaned after every 30 hours of use. Remove and clean by
hand or dishwasher. Use proper degreasing detergent for stainless steel and
leave to soak if heavily soiled. Dry filters and re-install before using hood.
Alpine Wall Operation
MAINTENANCE AND CLEANING
ALPINE WALL MODELS
MAINTENANCE AND CLEANING
ALPINE WALL MODELS
HOW TO CHANGE OR REPLACE LIGHT BULB
1. Make sure the range hood is unplugged or turn OFF breaker.
2. Slightly press inward on the bulb using both thumbs.
3. Keep your grip & pressure constant on the bulb with the thumbs as you turn
the bulb counter-clockwise. Stop pushing it inward once you feels it won’t turn
further (it should turn about 90 degrees)
4. Pull the bulb straight out of the socket
5. Have new light bulb legs to align with 2 socket base slot holes
6. Press the new bulb inward into the socket. You will press the bulb inward into the
same position that you took the old bulb out from. Twist it clockwise as far as it
will go, and you can turn the lights back on
CLEANING
• The saturation of greasy residue in the blower and filters may cause increased
inflammability. Keep unit clean and free of grease and residue buildup at all
times to prevent possible fires.
• FILTERS MUST BE CLEANED PERIODICALLY AND FREE FROM
ACCUMULATION OF COOKING RESIDUE.
• Do NOT operate blowers when filters are removed. Never disassemble parts to
clean without proper instructions.
• Disassembly is recommended to be performed by qualified personnel only. Read
and understand all instructions and warnings in this manual before proceeding.
• For optimal operation, clean range hood and all baffle/spacer /filter/grease
tunnel/oil container regularly. Regular care will help preserve the appearance
of the range hood.
CLEANING EXTERIOR SURFACES:
• Clean periodically with stainless steel cleaner or hot soapy water and clean
cotton cloth. Do NOT use corrosive or abrasive detergent (e.g. Comet Power
Scrub®, EZ-Off® oven cleaner), or steel wool/scouring pads, which will scratch
and damage the stainless steel surface. For heavier soil, use liquid degrease such
as “Formula 409®” or “Fantastic®” brand cleaner.
Loading ...
Loading ...
Loading ...