Loading ...
Loading ...
Loading ...
1615
Alpine Wall Installation
Alpine Wall Operation
7. Calculate the height of the duct tube and extend approximately 6” (15 cm)
longer than required, connect the lower end of the duct tube to the range hood
and the upper end to the vent system. Make sure the main electrical supply
remains disconnected then connect power plug to the electrical cord or wall
plug.
8. Have one person carefully position both upper and lower chimneys on the range
hood, let the second person slide the sides of the chimneys into the 1/8” gap.
Fasten both chimneys with four Type “C” screws.
9. Install grease cup and aluminum filters then check the operation of the range
hood.
INSTALLATION
ALPINE WALL MODELS
OPERATION
ALPINE WALL MODELS
• Power: Turn ON/OFF the range hood and activate power-off delay timer
(3mins).
• Low Speed: Light frying/boiling.
• Medium Speed: Frying/wok cooking/heavy boiling.
• High Speed: Intensive frying and wok cooking.
• Light: Turn ON/OFF
Adjusting the blower (motor) speed: Press the power key then press any speed
buttons one time , the blower will start at any speed, press same button again , shut
down the blower.
Adjusting the timer function: Turn the hood on at any speed and press the power-off
delay button one time, it will enter timer mode, power-off delay digital timer will
begin countdown. Press again ,the blower will shut down.
Never put your hand into area housing the fan while the fan is operating!
The remote control is a 433M high frequency remote control.
The distance of the remote control is 10 meters. The signal can
pass through the wall.
It needs to match code with the hood to use it for the first time.
Press Lamp key on range hood for 5 seconds. Once the light
of the lamp button on the hood flickers, press any button on
the remote control. If the LED of lamp button stops flickering,
the matching is done.
Loading ...
Loading ...
Loading ...