Loading ...
Loading ...
Loading ...
AXIS Q1602 N etwork Camera
System Options
The following trap s are available:
•Coldstart
•Warmstart
•Linkup
• Authentication failed
SNMP v3 provides encryption and s ecure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be e nabled, see HTTPS, on page 30. To enable SNMP v3, check the b ox and provide the initial user
password.
Note
The initial passwo rd can o nly be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to factory default settings, on page 40.
UPnP
TM
The Axis product includes support for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disa bled under System Options > N etwork > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings a re configured under System Options > Network > RTP.
The RTP port range defi nes the range of ports from which the video/audio ports are auto
matically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by op erating
systems and clients that support this protocol.
Bonjour can be disabled under System Options
>Network>Bonjour.
Storage
SD card
The SD/SDHC memory card (not included) is managed on the System Options > Storage page. Click SD card to open Storage
Management.
Mounting is done automatically when the card is inserted or when the product boots. SD cards are normally preformatted w hen
purchased, but if needed, click Format to forma t the card.
Note
To pre
vent corruption of recordings, the SD card should always be unmounted before removal.
If the card’s status shows as failed, click Check disk to see if the problem can be found and then try Re pair.
To avoid filling the card, it is recommended to remove recordings continuously. Under Recording Settings, select Remove recordings
older than and select the number of days or weeks.
To stop writing to the share a nd protect recordings from being removed, select Lock under Recording Settings.
36
Loading ...
Loading ...
Loading ...