Loading ...
Loading ...
Loading ...
4. Loosen the blade nut by turning it counterclockwise (as
viewed from bottom of mower) using a 16 mm wrench or
socket (not provided).
5. Remove the blade nut, spacer
, blade insulator, and blade.
6. Thread the blade nut on the shaft and finger tighten.
7. Torque the blade nut down clockwise using a torque
wrench (not provided) to ensure the bolt is properly
tightened. The recommended torque for the blade nut is
796~885 in. lbs.
WARNING
Ensure blade is properly seated and the blade nut is
tightened to the torque specifications above. Failure to
properly attach the blade could cause it to come loose
and result in possible serious personal injury.
8. Repeat with second blade, if needed.
NOTE
Make certain all parts are replaced in the exact order in
which they were removed.
11.3 REPLACE THE HEADLIGHT
LED Light
LED Light
Bolt
Bolt
1. Park the mower on a level surface and set the parking
brake.
2. Stop the motor and remove the start key.
3. Remove and set aside the hex head screw and flat washer
holding the mower floor panel in place.
4. Lift floor panel slightly to access the two hex head screws
and flat washers securing the headlight in place. Remove
screws and washers and set aside.
5. Unplug the old headlight and discard.
6. Plug in new headlight and reinstall washers and screws.
Tighten securely.
7. Lower floor panel and reinstall washer and screw to
secure.
11.4 LUBRICATION
Please add oil before operation.
Oil type SAE85W-90
Oil capacity 130 ml
Contact your Greenworks dealer to replace the lubrication.
NOTE
Replace the gearbox oil after you operate the machine for
50 hours for the first time, then replace the oil every 200
hours.
Oil ruler
Oil dra
in outlet
11.5 TORQUE VALUES
WARNING
Particular attention must be given to tightening the drive
wheel lug nuts and blade spindle bolts. Failure to correctly
torque these items may result in the loss of a wheel or blade,
which can cause serious damage or personal injury.
Torque values are given below:
Part Ft-lbs. Nm
Wheel (lug) nuts 89 120
Blade spindle bolt 66 90
Lug nuts only -It is recommended that these be checked after
the first 2 hours of operation, initially, every 100 hours and
following removal for repair or replacement.
For all other torques refer to the various mower parts manuals
for standard torque chart.
1
1.6 BATTERY PACK MAINTENANCE
Your Greenworks mower is powered by a battery pack which,
when maintained properly, will provide years of useful life.
For proper care, adhere to the following instructions:
•
Always charge batteries after each use.
• Whenever a battery pack is fully discharged and turned
off, it is best to recharge the battery as soon as possible.
Over-discharge of the battery pack means the battery life
will be shortened and the battery may become
permanently damaged. There is no need to fully charge; it
will be beneficial even if you only charge the battery pack
for 5-10 minutes. It is best to recharge it within 24 hours.
30
English
EN
Loading ...
Loading ...
Loading ...