Loading ...
Loading ...
Loading ...
37
ENGLISH
Never place cardboard, wood or
similar materials under the
machine to compensate for any
unevenness in the floor. Install the
machine on a flat hard floor. Make
sure that air circulation around the
machine is not impeded by carpets,
rugs etc.
When the washer-dryer is levelled,
try to rock it from corner to corner.
If it does rock, adjust the legs
again until it is levelled and does
not rock.
Connect the water inlet hose to a
tap with 3/4” BSP thread.
Use the hose supplied with the
washer-dryer. DO NOT USE OLD
HOSES.
The other end of the inlet hose
which connects to the machine can
be turned in any direction.
Simply loosen the fitting, rotate the
hose and retighten the fitting,
making sure there are no water
leaks.
13.3 Water Inlet
Check that the machine does not
touch the wall or cupboard units.
The inlet hose must not be
lengthened. If it is too short and you
do not wish to move the tap, you
will have to purchase a new, longer
hose specially designed for this
type of use.
This could be done by tying it to
the tap with a piece of string or
attaching it to the wall.
In a sink, drain pipe branch. This
branch must be above the trap
so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a
height of not less than 60 cm
and not more than 90 cm.
The end of the drain hose must
always be ventilated, i.e. the
inside diameter of the drain pipe
must be larger than the outside
diameter of the drain hose.
The drain hose must not be
twisted or curled. Run it along
the floor; only the part near the
drainage point must be raised.
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide
supplied with the machine.
In this case, make sure the end
cannot come unhooked when
the machine will be emptied.
13.4 Water Drainage
For the correct functioning of the
machine, the drain hose must
remain hooked on the proper
support piece situated on the top
part of back side of the appliance.
90 cm
60 cm
Loading ...
Loading ...
Loading ...