Loading ...
Loading ...
Loading ...
33
ENGLISH
In case of power failure or appliance failure, the appliance door remains locked. The wash
program continues when power is restored. If the door remains locked in case of failure, it is
possible to open it using the emergency unlock feature.
Before Opening The Door:
11.2 Emergency Door Opening
Malfunction Possible cause => Solution
The electronic unbalance detection device has cut in because the
laundry is not evenly distributed in the drum. The laundry is redistributed
by reverse rotation of the drum.
This may happen several times before the unbalance disappears and
normal spinning can resume. If, after 10 minutes, the laundry is still not
evenly distributed in the drum, the machine will not spin. In this case,
redistribute the load manually and select the spin program.
=> Pause the machine and redistribute laundry manually.
Machine not installed properly. => Make sure the levelling of the
appliance is correct. Refer to “Installation”.
Transit bolts or packaging not removed. => Make sure that the
packaging and/or the transit bolts are removed. Refer to “Unpacking”.
The load may be too small. => Add more laundry in the drum.
Machines based on modern technology operate very economically using
very little water without affecting performance.
Machine is optimizing the drying cycle according to the laundry type and
load size. It will vary for each kind of fabric as the water absorption is
different. => This is a normal behavior of the machine and not a cause
for concern as it does not compromise its performance.
The “Dry Time” or the “Dryness” degree has not been selected. => Select
the drying time or the dryness degree.
The water tap is not turned on. (Error code: ) => Open the water tap.
The machine is overloaded. => Reduce the laundry load in the drum.
The selected drying program, time or dryness degree was not suitable
for the laundry. => Select the suitable drying program, time or dryness
degree for the laundry.
The drain filter is clogged. (Error code: ) => Clean the drain filter.
Spinning starts
late or the
machine does
not spin:
The machine
makes an
unusual noise:
No water is
visible in the
drum:
Make sure that the water temperature and the laundry are not hot. Wait until they cool
down if necessary.
WARNING!
Make sure that the drum is not rotating. Wait until the drum stops rotating if necessary.
Make sure that the water level inside the drum is not too high. If necessary, perform
an Emergency Drain (see page 30).
The appliance calculated a new time according to the laundry load.
The cycle is
shorter than the
time displayed.
Display time is
frozen at the
end of drying
cycle for more
than 30 minutes:
The machine
does not dry or
does not dry
properly:
●
●
●
Loading ...
Loading ...
Loading ...