Loading ...
Loading ...
Loading ...
16 www.electrolux.com
To recall the favourite wash program,
press “Favourite ” program.
You will get acknowledgement on the
screen when the Favourite program is
loaded.
You can recall a favourite wash program
ONLY when the washer-dryer is in the
program selection mode. Otherwise
touching Favourite will have no effect.
3. To save favourite program, press
“Temp” and “Spin” touchpads at the
same time until the display shows the
wording “Program Saved”.
Child Safety Lock Option
Your appliance is provided with CHILD
SAFETY LOCK which permits you to
leave the appliance unsupervised with
the door closed without having to worry
that children might be injured by or cause
damage to the appliance.
Set this option after pressing the
Start/Pause touchpad.
Start/Pause and
Add Clothes Touchpad
To activate the function, press
“Dry Time and Dryness ”
touchpads at the same time until the
display shows the symbol “ ”.
To set “Child Lock” option:
This setting permits you to either enable
or disable the buzzer at the end of the
program. As an example, you might wish
to disable this buzzer when you start a
wash when going to bed, so that when the
wash finished approximately 1 hour later,
it will not disturb you through the night.
Error warning beeps such as critical
faults are not disabled.
Enabling/Disabling End-Of-Wash
Buzzer
To deactivate the function, press
“Dry Time and Dryness ”
touchpads at the same time until the
symbol “ ” goes off.
This function remains enabled
even after the appliance is
switched off.
The touchpads are locked
(except for the On/Off button).
●
●
This touchpad has 2 functions:
To disable the buzzer sound, press
“Dryness and Prewash ” touchpads
at the same time for 3 seconds, and listen
for “BEEP, BEEP”.
To return to default configuration press
these 2 touchpads at the same time for 3
seconds, and listen for “BEEP”.
●
Start/Pause
To interrupt a program which is
running, press this touchpad to pause
the machine, the Start/Pause pilot
light flashes.
After you have selected the desired
program and options, press this
touchpad to start the machine. The
Start/Pause pilot light will stop flashing
and remain lit until the water level is
above the bottom edge of the door
then pilot light goes OFF. If you have
selected a “Delay Start” option, the
countdown will begin and will be
shown in the display.
To restart the program from the point
at which it was interrupted, press this
touchpad again, the Start/Pause
pilot light will stop flashing.
●
Add Clothes
While running a program, you may add
clothes by:
Pressing the “Start/Pause ”
touchpad to pause the program.
You can only add clothes if
“Start/Pause” pilot light is lit.
-
Wait for the machine to come to a
complete stop before opening the
door.
-
Resume the program by pressing
“Start/Pause ” touchpad again.
-
Add clothing and close the door.
-
3.7
You cannot open the door if
the water inside the machine
drum are hot, the door remains
locked for your safety.
Although the LED light still
remain lit.
Loading ...
Loading ...
Loading ...