Loading ...
Loading ...
Loading ...
10
ASSEMBLY
Attaching the Seat (If necessary)
If the seat for your riding mower was not attached at the factory,
follow the applicable instructions below to attach it.
1. Remove the shoulder bolts (a) and lock nuts (b) from the seat
mounting bracket (c) included in your hardware pack. See
Figure 6.
(c)
(a)
(b)
(a)
(b)
Figure 6
2. Remove the two self-tapping bolts (a) factory-installed on
the riding mower. See Figure 7.
(a)
(a)
Figure 7
3. Align the seat bracket (a) in place over the holes from
where the self-tapping bolts (b) were removed, as shown in
Figure 8.
(a)(b)
(b)
Figure 8
4. Using a 1/4” drive ratchet with a 3/8” socket, secure the seat
bracket (a) with the self-tapping bolts (b) removed in Step 2.
See Figure 8.
CAUTION
Do not use any type of power tool (e.g. impact gun or
electric drill with nut driver attached) when tightening
the self-tapping bolts to attach the seat bracket.
5. Position the seat assembly over the seat mounting bracket,
aligning the holes provided.
6. Install the two shoulder bolts (a) and lock nuts (b) removed
from the seat mounting bracket (c) in Step 1. See Figure 9.
NOTE: Make sure that the bolt’s shoulder is completely recessed
into the seat bracket when securing the lock nut. See inset of
Figure 9.
(a)
(a)
(b)
(b)
(c)
(a)
(b)
(c)
Figure 9
Loading ...
Loading ...
Loading ...