Loading ...
Loading ...
Loading ...
Electrical Installation Tester
Safety
3
• Use the correct terminals, function, and range for
measurements.
• Do not apply more than the rated voltage between the
terminals or between each terminal and earth ground.
• Do not exceed the Measurement Category (CAT) rating of
the lowest rated individual component of a Product,
probe, or accessory.
• Keep fingers behind the finger guards on the probes.
• Measure a known voltage first to make sure that the
Product operates correctly.
• Replace the batteries when the low battery indicator
shows to prevent incorrect measurements.
• Remove all probes, test leads, and accessories before
the battery door is opened.
• Be sure that the battery polarity is correct to prevent
battery leakage.
• Repair the Product before use if the battery leaks.
• Have an approved technician repair the Product.
• Use only specified replacement parts.
• Replace a blown fuse with exact replacement only for
continued protection against arc flash.
• Do not operate the Product with covers removed or the
case open. Hazardous voltage exposure is possible.
• Disable the Product if it is damaged.
• Do not use the Product if it is damaged.
• Remove the input signals before you clean the Product.
• Use only current probes, test leads, and adapters
supplied with the Product.
• Remove test leads from the Product before the case is
opened.
• Do not use in CAT III or CAT IV environments without the
protective cap installed. The protective cap decreases
the possibility of arc flash caused by short circuits.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...