Loading ...
Loading ...
Loading ...
Sarix® Modular Camera Operations Manual
C6719M | 02/22
9
Settings.
Caution: The time setting must always be current. To ensure that the time is always current
you should do one of the following:
- Set up NTP on the DHCPserver, if your VMSsupports this feature.
- Use a valid public NTP server.
- Manually set the correct time in the Time Settings fields.
8. Click Apply to save the settings.
Managing the Camera Firmware
The Firmware page provides the current firmware version. From this page, you can also manually upgrade
the firmware, reboot the device, and restore to the factory defaults.
l To manually upgrade the camera firmware:
1. Download the latest version of the firmware .bin file from the Pelco website
(www.pelco.com/training-support/).
2. Click the System tab, and then click the Firmware button.
3. Click Choose File, and then browse to and locate the downloaded firmware file.
4. Click Upgrade. Wait until the camera upgrade is complete.
l To reboot the camera, in the Reboot Device area, click Reboot.
l To restore the camera to factory defaults, in the Restore to Factory Defaults area, click Restore.
l To reinitialize the lenses, in the Reinitialize Lens area, click the appropriate Lens # or click All to
reinitialize all lenses.
This is used when one or more lenses have temporarily lost communication or focus settings with
one or more cameras. By reinitializing, the camera will reestablish communication with the lens.
Afterward, you can refocus the lens using the focus controls.
Configuring Storage Management
On the Storage Management page, you can enable the camera’s onboard storage feature and download
recorded video directly from the camera. Onboard storage is available only on cameras equipped with an
SDcard or microSD card slot.
To access the Storage Management page, click the System tab, and then click the Storage Management
button.
Current information about the camera is presented in theDevice Information section at the top of the page.
It includes Status, Capacity, Current Usage, Remaining Capacity, and Measured Write Speed.
You can perform two actions in the Device Information area:
l To format the SDcard, click Format Card.
l Click to select or deselect the checkbox for Enable video alert overlay on severe SDcard failure.
When enabled, this feature shows an overlay on the video stream when the card cannot record
video, indicating that you must replace the card.
Loading ...
Loading ...
Loading ...