Loading ...
Loading ...
Loading ...
Sarix® Modular Camera Operations Manual
C6719M | 02/22
28
Configuring Events
Use the Events tab to configure Motion, Sabotage, and DIOsettings.
Caution:The Sarix Modular Camera has multiple camera heads in a single camera. Some settings
apply to the camera as a whole; other settings apply to individual heads. Certain multi-head camera
settings can be set globally for all of the heads. Other settings must be set for each individual head.
When configuring a camera, configure both the global and the individual head settings.
Configuring Motion Detection
On the Motion Detection page, you can define the green motion detection areas in the camera’s field of
view. Motion detection is ignored in areas not highlighted in green.
To help you define motion sensitivity and threshold, motion is highlighted in red in the image panel.
Note: This motion detection setting configures pixel change detection in the camera's field of view. If
you are configuring a Pelco video analytics camera, you will need to configure the detailed analytics
motion detection and other video analytics features through the Client software.
1. Click the Events tab, and then click the Motion button.
2. For each camera head, click Head [#] to select the head to configure, and then perform the following
steps.
3. Define the motion detection area.
The entire field of view is highlighted for motion detection by default. To define the motion detection
area, use any of the following tools:
l Click Clear All to remove all motion detection areas on the video image.
l Click Set All to set the motion detection area to span the entire video image.
l To set a specific motion detection area, click Select Area then click and drag anywhere on the
video image.
l To clear a specific motion detection area, click Clear Area then click and drag over any motion
detection area.
l Use the Zoom In and Zoom Out buttons to locate specific areas in the video image.
4. In the Sensitivity field, enter a percentage number to define how much each pixel must change
before it is considered in motion.
The higher the sensitivity, the smaller the amount of pixel change is required before motion is
detected.
5. In the Threshold field, enter a percentage number to define how many pixels must change before
the image is considered to have motion.
The higher the threshold, the higher the number of pixels must change before the image is
considered to have motion.
6. If the camera is connected to a third-party video management system (VMS), click AllHeads, and
then click to select the checkbox for Enable Onvif MotionAlarm Event.
When it is enabled, the H.264 camera can send motion alarm information to the VMS according to
the appropriate ONVIF protocol.
7. Click Apply to save the settings.
Loading ...
Loading ...