Loading ...
Loading ...
Loading ...
En-6
AUTO mode (Auto change over)
The unit selects the operation mode according to the difference between the
room temperature and the set temperature. During AUTO mode, the unit
changesmode(COOL↔HEAT)whentheroomtemperatureisabout2°C
away from the set temperature for more than 15 minutes.
Note:
Auto Mode is not recommended if this indoor unit is connected to a MXZ
type outdoor unit. When several indoor units are operated simultaneously,
the unit may not be able to switch operation mode between COOL and
HEAT. In this case, the indoor unit becomes standby mode (Refer to table
ofOperationindicatorlamp).
COOL mode
Enjoy cool air at your desired temperature.
Note:
Do not operate COOL mode at very low outside temperatures (less than
-10°C).Watercondensedintheunitmaydripandwetordamagefurni-
ture, etc.
Note:
Operation indicator lamp
The operation indicator lamp shows the operation state of the unit.
Indication Operation state Room temperature
The unit is operating to reach the set
temperature
About2°Cor more
away from set tem-
perature
The room temperature is approach-
ing the set temperature
About1to2°Cfrom
set temperature
Demand Response mode Page 12 —
Lit Blinking Not lit
1
Press
to start the operation.
2
Press to select operation mode. Each press
changes mode in the following order:
3
Press or to set the temperature.
Eachpressraisesorlowersthetemperatureby1°C.
Press to stop the operation.
S
ELECTING OPERATION MODES
(AUTO) (COOL) (DRY) (HEAT) (FAN)
DRY mode
Dehumidify your room. The room may be cooled slightly.
Temperature cannot be set during DRY mode.
HEAT mode
Enjoy warm air at your desired temperature.
FAN mode
Circulate the air in your room.
Note:
After COOL/DRY mode operation, it is recommended to operate in the
FAN mode to dry inside the indoor unit.
JG79Y723H02.indd 6 2020/10/26 14:05:43
Loading ...
Loading ...
Loading ...