Loading ...
Loading ...
Loading ...
En-5
● OPERATING INSTRUCTIONS ●
Before operation: Insert the power supply plug into the power outlet and/or
turnthebreakeron.
Installing the remote controller batteries
1.
Remove the front lid.
2.
Insert the negative
poleofAAAalkaline
batteriesrst.
3.
Install the front lid.
4.
Press RESET.
Setting current time
1.
Press CLOCK.
4.
Press CLOCK again.
2.
Press either the TIME button
or the TIMER buttons to set
the time.
Eachpresschangestheclock
1minuteforward/backward(10
minuteswhenpressedlonger).
3.
Press the DAY button
to set the day.
PREPARATION BEFORE OPERATION
Note:
• Makesurethepolarityofthebatteriesiscorrect.
• Donotusemanganesebatteriesandleakingbatteries.Theremotecontroller
could malfunction.
• Do not use rechargeable batteries.
• The battery replacement indicator lights up when the battery is running low.
In about 7 days after the indicator starts lights up, the remote controller stops
working.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with ex-
pired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Note:
• Press CLOCK gently using a thin instrument.
Note:
How to set remote controller exclusively for a particular indoor unit
A maximum of 4 indoor units with wireless remote controllers can be used in
a room.
To operate the indoor units individually with each remote controller, assign a
number to each remote controller according to the number of the indoor unit.
This setting can be set only when all the following conditions are met:
• The remote controller is powered OFF.
(1)Holddown
button on the remote controller for 2 seconds to enter the
pairing mode.
(2)Press
button again and assign a number to each remote controller.
Each press of
buttonadvancesthenumberinthefollowingorder:1→
2→3→4.
(3)Press
button to complete the pairing setting.
AfteryouturnthebreakerON,theremotecontrollerthatrstsendsasignal
to an indoor unit will be regarded as the remote controller for the indoor unit.
Once they are set, the indoor unit will only receive the signal from the as-
signed remote controller afterwards.
JG79Y723H02.indd 5 2020/10/26 14:05:42
Loading ...
Loading ...
Loading ...