Loading ...
Loading ...
Loading ...
18
INSTALLATION
Stacking - 6 & 10 Mini Ovens
7. Install riser bracket on back of lower oven as follows:
a. Using a Phillips head screw driver, remove the top screw holding the left side body panel to the rear of the oven.
Keep this screw it will be used to mount the riser bracket to the rear of the oven.
b. Slide the riser bracket down the two risers installed in the previous step. Keep the bracket stays level while sliding
down the risers, otherwise it will become stuck.
c. Slide the bracket under the sheet-metal lip just below the controller box. The hole in the bracket should line up with
the threaded hole the previously removed screw came from.
d. Secure the bracket using a Philips head screw driver and the screw previously removed.
Slide the bracket down from the top Slide racket in place under the lip
Tightening the Phillips screw Bracket installed
Figure 26
8. Install overow elbow as follows:
a. Use a 3/8” nut driver to tighten the hose clamp for the drain coupler. A customer supplied drain will still need to be
attached at the other end of the drain coupler.
b. Install the overow elbow to the port next to the drain coupler on both ovens.
Tightening the hose clamp for the drain coupler Install the spring clamp for the overow
elbow
Figure 27
Loading ...
Loading ...
Loading ...