Loading ...
Loading ...
Loading ...
17
INSTALLATION
Stacking - 6 & 10 Mini Ovens
4. Push the elbow on from above at the approximate angle shown in the image below. After the elbow is fully seated,
slightly twist the elbow clockwise until approximately half of the elbow face width is under the cross bar of the stand.
Figure 23
5. Install the second elbow in a similar manner as in Step 4. When stacking the BLCT-6 on a BLCT-10, ensure that there
is slight clearance between top of the elbows and the stand rear crossbar.
Figure 24
6. Install the top oven on the stand using the method out-
lined in step 2.
Install the two risers, one for the vent and the other for
the exhaust by pushing them onto the elbows previ-
ously installed. Both of the risers are the same in t,
form, and function.
If some time has passed since the soapy water was
applied to the O-rings, now is a good time to reapply.
Figure 25
Loading ...
Loading ...
Loading ...