Loading ...
Loading ...
Loading ...
Electrical Installation Tester
Memory Mode
65
Store a Measurement
To store a measurement:
1. Press to enter Memory mode.
2. Press and use the arrow button () to set the location identity.
3. Press to save the test results.
• The test results are saved, the Tester will automatically exit Memory
mode and the display will revert back to the previous test mode.
• If memory is full, FULL will appear on the primary display. Press
to exit Memory mode.
Note
ERR9 in the primary display indicates a data problem. See
Table 9 for more information.
Recall a Measurement
To recall a measurement:
1. Press to enter the Memory mode.
2. Press to enter the Recall mode.
3. Use and to set the location identity. Only memory locations with stored
measurements will show on the display. All fields show as dashes if no test
result is stored.
4. Press to recall the test result. The Tester display will revert to the Test
mode used for the recalled test results. Also, the and
icons remain on the display to indicate that the Tester is in Memory Recall
mode.
5. Press to step through multiple tests that are saved at the selected
location identifier. Only the main result for each test is shown, for example
Z
L
for loop test, but no Zmax.
6. When multiple results are saved as part of a single test, press to step
through the results of that test.
7. Press to clear the test result. The primary display shows Clr?. Press
again to clear the recalled location.
8. Press to toggle between the location ID screen and the recalled test
result screen to check the recalled location ID or to select more test results
to recall.
9. Press to exit Memory mode at any time.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...