Loading ...
Loading ...
Loading ...
Fall Detection Radar User Manual
24
parameters.
Steps
1. Go to Configuration → System → Maintenance → Upgrade & Maintenance → Device
Maintenance.
2. Select the restoration mode.
– Click Restore and click OK. Then the parameters except the IP parameters, user parameters,
and the saved parameters will be restored to the default settings.
– Click Restore Factory Settings and click OK to restore all the parameters to the factory
settings.
3. Click OK.
8.6 Set Serial Port
Set RS-232 parameters if you need to debug the device via RS-232 serial port.
Before You Start
The debugging device has been connected via the RS-232 serial port.
Steps
1. Go to Configuration → System → System Settings → Serial Port.
Figure 8-1 Set RS-232
2. Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
3. Select Work Mode.
Console
Select it when you need to debug the device via RS-232 serial port.
Transparent Channel
Select it, and the network command can be transmitted to RS-232 control command via the
RS-232 serial port.
Narrow Bandwidth Transmission
Reserved.
4. Click Save.
Loading ...
Loading ...
Loading ...