Loading ...
Loading ...
Loading ...
ICE MAKING ASSEMBLY SYSTEM CLEANING BY USING NU-CALGON NICKLE SAFE
Ice-machine Cleaner
Minerals that are removed from water during the freezing cycle will eventually form a hard, scaly
deposit in the water system. Cleaning the system regularly helps remove the mineral scale buildup.
How often you need to clean the system depends upon how hard your water is. With hard water of 4
to 5 grains/liter, you may need to clean the system as often as every 6 months
1. Turn off the ice maker. Keep the ice maker connected to the water supply and drainpipe but shut off
the water faucet of main water supply.
2. Open the door and scoop out all the ice cubes. Either discard them or save them in an ice chest or
cooler.
WARNING
Wear rubber gloves and safety goggles (and/or face shield) when handling Ice Machine Cleaner or
sanitize
3. Make the cleaning solution by mixing the Nu-Calgon Nickle Safe Ice Machine Cleaner with water.
Use a plastic or stainless-steel container with more than 4 liters of capacity. Mix 300 ml Nu-Calgon
Nickle Safe Ice-machine Cleaner and 2.8 liters warm water at about 120F-140F. Then, divide them for
2 shares equally in 2 cups. It is better to keep the same temperature for each cup.
4. Check to be sure that the water tank’s drainpipe has been installed properly in the slot of the tank
wall. Then, pour one cup of Nickel-Safe Ice Maker Cleaning Solution into the water tank. Wait about
for 5 minutes.
5. Turn on the power to the ice maker, then press the “TIMER CLEAN” button on the control panel for
more than 5 seconds to enter the self-cleaning program. The water pump runs for 8 minutes and
stops for 3 minutes and repeats this process for the total duration time of 30 minutes. During this
process, the “CLEAN” light will and the digit window will indicate the remaining time.
6. After 30 minutes of one self-cleaning program has been completed, pull out the water tank’s
drainpipe and drain the cleaning solution down to the lower ice storage bin. Shake the unit slightly to
drain out all the cleaning solution completely. Then, reinstall the drainpipe to the slot of the water
tank.
7. Repeat steps 4-6 to clean the ice making assembly system again
Loading ...
Loading ...
Loading ...