Loading ...
Loading ...
Loading ...
-12-
Model W1830 (For Machines Mfd. Since 4/15)
SETUP
Test. Run
Once you have unpacked the machine, perform a test
run before mounting to the ceiling to make sure it runs
properly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review the Troubleshooting on Page.
20.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To.test.run.the.machine,.do.these.steps:
1. Make sure you have read the safety instructions at
the beginning of the manual.
2. Place the air filter on a workbench or similar stable
surface that can support the load.
3. Connect the air filter to power.
4. Press the ON SPEED button on the control panel of
the air filter (see Figure.5) to turn the unit ON. The
machine should begin to operate.
— Strange or unusual noises should be investigated
and corrected before operating the machine
further. Always disconnect the machine from
power when investigating or correcting potential
problems.
Note: Do not be alarmed if you notice a small
amount of vibration during the Test Run. It is
normal for all air filters to produce a small
amount of vibration during operation. This
vibration is much more noticeable when operating
on a hard surface, such as a workbench, compared
to when operating in a suspended position, as
designed.
5. Push the ON SPEED button repeatedly to cycle
through the three air flow speed options. The lights
on the control panel should display the selected
speed.
6. Press the OFF button to turn the machine OFF.
7. Point the remote control directly at the control
panel, and press the remote control ON SPEED
button to turn the machine ON.
Figure.5. Air filter control panel.
8. Push the remote control ON SPEED
button (see Figure.6) repeatedly to
cycle through the air flow options.
The lights on the control panel should
display the selected speed.
9. Push the remote control TIME button
repeatedly to cycle through the three
time options. The lights on the control
panel should display the amount of
time the air filter will run before
automatically turning OFF.
10. Press the remote control OFF button
to turn the air filter OFF.
Figure.6. Remote control.
Loading ...
Loading ...
Loading ...