Loading ...
Loading ...
Loading ...
14 PawRunner User Manual Lifepro
Endurance Training Collection 15
ATTACH VELCRO
®
STRIPS TO THE SIDEBARS
You will need: 8 Velcro
®
strips (D), left sidebar (E),
right sidebar (F)
NOTE: The two sidebars are identical until the Velcro
®
strips are applied,
then one will be the left sidebar (E) and the other will be the right
sidebar (F).
1. Set one sidebar on the ground on the left side of the treadmill.
2. Loop four Velcro
®
strips (D) along the sidebar:
• The smooth side of the Velcro
®
strip will face to the INSIDE (RIGHT)
of the treadmill. The hook and loop side of the Velcro
®
strip will face
to the OUTSIDE (LEFT) of the treadmill.
• Loop just enough of the Velcro
®
strip around the crossbar to be able
to close the loop. The rest will extend straight out creating a Velcro
®
tab. This tab will be used to attach the fabric side panels.
• Position three loops along the long side of the sidebar and one loop
on the short side of the sidebar.
• The loops should be loose enough that they can be repositioned
along the side panel, if necessary.
3. Lay the left sidebar (E) on the ground until the next step.
4. Set the second sidebar along the right side of the treadmill.
5. Loop four Velcro
®
strips (D) along the sidebar in the same manner:
• The smooth side of the Velcro
®
strip will face to the INSIDE
(LEFT) of the treadmill. The
hook and loop side of the
Velcro
®
strip will face to the
OUTSIDE (RIGHT) of the
treadmill.
6. Lay the right sidebar (F) on the
ground until the next step.
4
INSTALL THE SIDEBARS TO THE BASEFRAME
You will need: left sidebar (E), right sidebar (F),
4 M6x6 screws (L), 4 curved washers (M), hex key (N)
5
1. Insert the left sidebar (E) (the Velcro
®
tabs face OUTSIDE/LEFT) onto
the rounded inserts on the left side of the crossbar and on the top of
the baseframe.
2. Put a curved washer (M) onto one of the screws (L).
3. Insert the screw/washer combination through the screw holes in the
left sidebar (E) and crossbar (C). Don’t tighten the screw yet.
4. Place another washer onto another screw.
5. Insert the screw/washer combination through the screw holes in the
sidebar (E) and baseframe (A). Don’t tighten the screw yet.
6. Repeat 1–5 above to attach the right sidebar (F) to the right side of the
crossbar (C) and baseframe (A).
7. Use the hex key (N) to fully tighten all four screws.
A
(L)
(M)
x4
x4
TOOLS & HARDWARE
(N)
L
M
F
B
E
L
M
Loading ...
Loading ...
Loading ...