Loading ...
Loading ...
Loading ...
12 PawRunner User Manual Lifepro
Endurance Training Collection 13
ATTACH THE CROSSBAR TO THE BASEFRAME
You will need: crossbar (C), 2 M6×6 screws (L),
2 curved washers (M), hex key (N)
ATTACH VELCRO
®
STRIPS TO THE CROSSBAR
You will need: crossbar (C), 2 Velcro
®
strips (D)
1. Insert the base of the crossbar (C) onto the two round inserts on either
side of the treadmill baseframe (A), just behind the motor housing.
2. Place a curved washer (M) onto one of the screws (L).
3. Insert the screw/washer combination through the screw holes on the
left side of the crossbar (C) and into the baseframe (A).
4. Repeat 3–4 above to attach the right side of the crossbar to the
baseframe.
5. Use the hex key (N) to fully tighten each screw.
1. Loop one Velcro
®
strip (D) around the left side of the crossbar (C) and
one strip around the right side:
• The smooth side of the Velcro
®
strip will face to the INSIDE of
the treadmill. The hook and loop side of the Velcro
®
will face to the
OUTSIDE of the treadmill.
• Loop just enough of the Velcro
®
strip around the crossbar to be
able to close the loop. The rest of the strip will extend straight out
creating a Velcro
®
tab. This tab will be used to attach the fabric side
panels.
• Position the two loops a few inches from the base of the crossbar.
• The loops should be loose enough that they can be repositioned
along the crossbar, if necessary.
C
C
D
A
D
(L)
(M)
x2
x2
TOOLS & HARDWARE
(N)
L
M
32
Loading ...
Loading ...
Loading ...