Loading ...
Loading ...
Loading ...
To Add Oil
Drain tank to
release air pressure
before removing the oil fill cap or
oil drain plug.
1. Place unit on a level surface.
2.
Remove oil fill plug (A) and
slowly add compressor oil until it
is even with the top of the oil fill
hole. NOTE: Do not allow oil to
be lower than 3/8" (6 threads)
from the top at any time. When
filling the crankcase, the oil flows
very slowly into the pump. If the
oil is added too quickly, it will
overflow and appear to be full.
NOTE: Crankcase oil capacity is
approximately 16 fluid ounces.
3. Replace oil fill plug.
Air Compressor Location
• Locate the air compressor in a
clean, dry, and well ventilated
area.
The air compressor should be
located at least 12" away from
the wall or other obstructions
that will interfere with the flow of
air.
The air filter and flywheel must
be kept clear of obstructions
which could reduce air flow to
the air compressor.
The air compressor requires
fresh air flow for proper cooling.
DO NOT ALLOW THE
COMPRESSOR TO GET WET.
GROUNDING INSTRUCTIONS
_ RISK OF
ELECTRICAL
SHOCK, In the event of a short
circuit, grounding reduces the risk
of shock by providing an escape
wire for the electric current. This
air compressor must be properly
grounded.
The portable air compressor is
equipped with a cord having a
grounding wire with an appropriate
grounding plug (see following
illustrations). The plug must be used
with an outlet that has been installed
and grounded in accordance with all
local codes and ordinances.
1. The cord set and plug with this
unit contains a grounding pin.
This plug MUST be used with a
grounded outlet.
IMPORTANT: The outlet being used
must be installed and grounded in
accordance with all local codes and
ordinances.
2. Make sure the outlet being used
has the same configuration as
the grounded plug. DO NOT
USE AN ADAPTER. See
illustration.
Plug
Gm_ Grounded
Outlets
D30090 12- ENG
Loading ...
Loading ...
Loading ...