Loading ...
Loading ...
Loading ...
13
Bottom Entry
Loosen the left cable gland and insert the AC input cable
into the AC inlet hole.
Step 2
1. Strip the wires to 1/2" (12 mm).
2. Connect the wires (L1, L2, and Ground) as per the
diagram and tighten each connector screw to 17.7
in·lbs (2 N·m).
3. For Bottom entry: Reinstall the left strain relief by
inserting and tightening the two screws. Then tighten
the left cable gland.
4. Reconnect the cables which was removed from STEP
5 Removing the Covers.
5. If the connection to the Ethernet cable and/or RS485
cables (see
Section 3.5 and 3.6) are not needed,
reinstall the faceplate and middle cover and tighten
the screws.
Loading ...
Loading ...
Loading ...