Loading ...
Loading ...
Loading ...
8
208 VAC Panel
1. Main Breaker
2. PE Bus
3. L1
4. L2
5. L3
6. Local Service or Sub Panel
7. L1
8. L2
9. PE
10. Input Terminal Block
11. Output Terminal Block
3.1.2 Grounding Requirements
The charger must be connected to a grounded, metal, and permanent wiring system. An equipment-
grounding conductor must be run with circuit conductors and connected to an equipment-grounding
terminal or lead on the charger.
A grounding conductor that complies with applicable codes must be grounded to earth at the service
equipment or, when supplied by a separate system, at the supply transformer.
Neutral is not used to power the charger but must be properly connected to ground, at the panel transformer,
to provide necessary voltage reference relative to ground.
3.2 Preparing for Installation
Install the charger on a flat and vertical surface capable of supporting its weight (e.g., a finished wall or
pedestal). The maximum weight of a MaxiCharger AC Elite (commercial) is approximately 14.8 lbs. (6.7
kg).
Install the charger in a location that allows the charging cable to remain within its bending tolerance.
Position the charger in a location where it is not vulnerable to being damaged.
Ensure the electrical panel supports a 240 V dedicated circuit with a new, dedicated, and non-GFCI two-
pole circuit breaker, in accordance with local codes and ordinances.
The recommended installation height for the charger is between 33 and 45 inches (850 and 1150 mm).
The minimum outdoor installation height is 24 inches (600 mm) and that of indoor is 18 inches (450 mm).
Loading ...
Loading ...
Loading ...