Loading ...
Loading ...
Loading ...
Care and Cleaning
Professional Outdoor Grills & Cooktops
Batterbl
replacement
The grill has a battery back-up which provides
power to the grill ignition system, allowing it to
operate when not connected to an ACoutlet
or during an electrical power outage.
For built-in grill models, the battery location
varies depending on where the installer located
it during installation.
For free-standing models, the battery is located
on the back side of the grill behind the lower
access panel.
To access and remove the batterg:
1. On free-standing models, remove the
back panel access screws. (On built-in
models, locate and access the battery
from the front of the grill.)
Retaining
flange
panel
2. Remove the back panel by lowering it
from under the upper retaining flange.
Retaininc
flange : ::::_-
c:
location
i
NOTE:You may find it more convenient to
access the battery and fuse by removing the
roller-supported drawers and reaching to the
rear wall support bracket. You may also extend
the slide-supported tall drawer to reach the rear
of the grill. To remove the drawers, pull forward,
tilt up and pull out on the drawer.
3. Remove the battery/fuse-mounting assembly
from the lower right inside wall of the grill by
firmly grasping it and pulling it straight up.
4. Usea coin or small screwdriver to open
the battery drawer by pressing up on its
access slot.
(
slot in
drawer
5. Replace with a new 9-volt battery being
careful to insert it in the battery drawer
by the keyed terminal size.
'ed
terminal size
To replace:
1. Closethe battery drawer firmly into the
battery/fuse-mounting assembly.
2. Make sure the wiring terminal cover is over
the wiring terminal connections.
rwiring
terminal
3. Slide the battery/fuse-mounting assembly
down over its retaining bracket on the inside
back wall of the grill.
4. Replacethe lower back panel by sliding it
under the upper retaining flange and securing
all screws removed earlier.
Battery/fuse-
mounting
assembly
28
Loading ...
Loading ...
Loading ...