Loading ...
Loading ...
Loading ...
9
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
* Side clearances can be 50mm when adjacent surface is at least 100mm below cooking surface.
NOTE:
All Models are delivered completely assembled. No further assembly is required.
This appliance is fitted with adjustable feet to enable appliance to be positioned securely
and level. This should be carried out on completion of gas connection. Refer to ‘Gas
Connection’ section.
Optional Accessories (Refer to Replacement Parts List)
Plinth Kit. For installation details, refer to instructions supplied with each kit.
1. Check that all feet (or castors) are securely fitted.
2. Adjust feet to make oven range steady and level.
NOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON.
1. Blue Seal Ranges do not require an electrical connection, as they function totally on gas supply only.
2. It is essential that gas supply is correct for appliance being installed and that adequate supply
pressure and volume are available. The following checks should be made before installation:-
a. Gas Type the appliance has been supplied for is shown on coloured
stickers located above gas connection and on rating plate. Check that
this is correct for gas supply appliance is being installed for. Gas
conversion procedure is detailed in this manual.
b. Supply Pressure required for this appliance is shown in
‘Specifications’ section of this manual. Check gas supply to ensure
adequate supply pressure exists.
c. Input Rate of this appliance is shown on Rating Plate and in
‘Specifications’ section of this manual. Input rate should be checked
against available gas supply line capacity. Particular note should
be taken if appliance is being added to an existing
installation.
NOTE: It is important that adequately sized piping runs directly to connection joint on appliance
with as few tees and elbows as possible to give maximum supply volume.
3. Fit gas regulator supplied, into gas supply line as close to appliance as possible.
Left / Right hand side 250mm (*) 0mm
Rear 100mm 0mm
Rating Plate
Location
Fig 1
Loading ...
Loading ...
Loading ...