Loading ...
Loading ...
Loading ...
350 IN CASE OF EMERGENCY
Front Jacking Location
Rear Jacking Location
When changing a rear wheel, assemble the
jack driver to the jack and connect the jack
driver to the extension tubes. Place the jack
under the axle between the spring and the
shock absorber with the extension tubes ex-
tending to the rear.
Rear Lifting Point
Rear Jacking Location
Connect the extension tubes and lug wrench.
NOTE:
If the bottle jack will not lower by turning the dial
(thumbwheel) by hand, it may be necessary to use
the jack driver in order to lower the jack.
4. By rotating the lug wrench clockwise, raise the
vehicle until the wheel just clears the surface.
CAUTION!
Before raising the wheel off the ground, make
sure that the jack will not damage surrounding
truck parts and adjust the jack position as
required.
WARNING!
Raising the vehicle higher than necessary can
make the vehicle less stable. It could slip off the
jack and hurt someone near it. Raise the vehicle
only enough to remove the tire.
20_DJD2_OM_EN_USC_t.book Page 350
Loading ...
Loading ...
Loading ...