Loading ...
Loading ...
Loading ...
10 SculptTrainer Lite User Manual Lifepro Strength Training Collection 11
ATTACH THE SUPPORT PADS
TO THE SUPPORT BAR
1. Place the Support Pads (F) side-by-side with the screw holes facing up.
2. Position the two cross brackets of the Support Bar (E) over the
Support Pads (F), aligning the four holes in the cross brackets with the
holes in the Support Pads (F).
3. Attach the Support Bar (E) to the Support Pads (F) using 4 bolts
and 4 washers (N).
ATTACH THE HANDLES
TO THE SUPPORT BAR
1. With the Support Pads (F) facing down, attach both Handles (J) to the
Support Bar (E) using 2 bolts, 4 washers, and 2 nuts.
Note: Check left and right Handle orientation; when the Support Bar is
lying flat the Handles will angle up toward the top of the Support Pads.
4
F
E
5
F
E
J
J
ATTACH THE SUPPORT BAR
TO THE FRONT MAIN FRAME
1. Insert the Support Bar (E) into the opening at the top of the Front
Main Frame (C).
2. With the Adjustment Knob (L) partially screwed in, pull the knob head
out and slide the Support Bar (E) up or down until you hear a “click”
indicating that it is locked in position. There are 6 height-adjustment
holes on the Support Bar (E).
3. Turn the Adjustment Knob (L) clockwise to tighten it and secure the
Support Bar (E) in place at the desired height.
6
C
E
L
N
(x4)
M8x40mm Bolt +
Washer
N
Q
Q
M10x60mm Bolt +
Washers + Nut
*Place 1 washer under
each bolt head and
1 washer under each nut
(x2)
Loading ...
Loading ...
Loading ...