Loading ...
Loading ...
Loading ...
Installation Instructions
TEST FOR LEAKS
WARNING - Never useanopen
flame to test for gas leaks.
Check all connections for leaks with soapy solution
or equivalent.
Apply a soap solution. The leak test solution must
not contain ammonia, which could cause damage
to the brass fittings.
If leaks are found, close the valve, retighten the joint
and repeat the soap test.
Open Gas
ELECTRICAL CONNECTION
INFORMATION FOR GAS DRYERS
A WARNING - Toreducetheriskof
fire, electrical shock and personal injury:
. Do not use an extension cord or an adapter plug
with this appliance.
. The dryer must be electrically grounded in
accordance with local codes and ordinances, or
in the absence of local codes, in accordance with
the NATIONAL ELECTRICAL CODE, ANSI/NFPA NO.
70 or Canadian Electrical Code, CSA C22.1
ELECTRICAL REQUIREMENTS FOR GAS
DRYERS
This appliance must be supplied with 120V, 60Hz,
and connected to a properly grounded branch
circuit, protected by a 15- or 20-amp circuit breaker
or time-delay fuse.
If electrical supply provided does not meet the
above specifications, it is recommended that a
licensed electrician install an approved outlet.
AWARNING -This dryerisequipped
with a three-prong (grounding) plug for your
protectionagainst shock hazard and should be
plugged directly into a properly grounded
three-prongreceptacle.Do not cut or remove the
grounding terminalfrom thisplug.
Ensure proper
ground exists
before use.
/II IIII
If local codes permit, an external ground wire (not
provided), which meets local codes, may be added
by attaching to the green ground screw on the rear
of the dryer, and to an alternate established ground.
Ensure proper ground exists before use.
Ground
Screw
21
Loading ...
Loading ...
Loading ...