Loading ...
Loading ...
Loading ...
29
Cycle at Bin
Control Activation
Shutdown
Fill Cycle 15 sec. after activation.
Harvest Cycle If engaged 15 sec. or longer, at the end of harvest cycle.
Freeze Cycle 15 sec. after activation if activated at least 15 sec. before the 5-min. short cycle
protection timer terminates. Otherwise, at the end of the next harvest cycle.
Ice Level in Bin Control Board
"OPEN/CLOSED" LED
Bin Control Controller
LED 1
Empty OFF ON
Full ON OFF
5) Once the icemaker restarts, move the control switch to the "OFF" position, then turn off
the power supply.
6) Replace the base cover in its correct position.
7) Move the control switch to the "ON" position. Replace the front panel in its correct
position, then turn on the power supply.
8) Allow the icemaker to operate for 10 min.
9) After 10 min., turn off the power supply, then remove the front panel.
10) Move the control switch to the "OFF" position, then remove the base cover and
disconnect one end of the pump tubing to drain the water tank. See Fig. 17.
11) After the water tank has drained, reconnect the pump tubing.
12) Clean the dispenser unit/ice storage bin liner using a neutral cleaner. Rinse thoroughly
after cleaning.
13) Replace the base cover in its correct position. Move the control switch to the "ON"
position. Replace the front panel in its correct position.
14) Turn on the power supply to start the
automatic icemaking process.
15) On water-cooled models, conrm
proper condenser drain outlet/return
outlet temperature as outlined in "II.F.2.
Water-Cooled Condenser."
4) As water begins to ll the water tank (1-min. ll),
place an object 5" to 7" (127 to 178mm) away
from the bin control lens. See Fig. 16. 15 sec. later,
the icemaker shuts down. Remove the object from
the bin control lens. 30 sec. later, the icemaker
restarts.
Disconnect This
End of Pump
Tubing to Drain
Water Tank
Base Cover
Fig. 16
Bin Control Lens
Fig. 17
Loading ...
Loading ...
Loading ...